Problem Configuring Access Mode on an Interface on a Catalyst 3500XL
I want to configure several FastEthernet interfaces on a Catalyst
3500XL switch so they will not trunk. I used the following command:conf t int fa0/1 switchport mode access
It takes the command o.k. but when I do a sh run it does not show that the interface is in access mode. Moreover, when I connect another switch to fa0/1 with at cross-over cable, it trunks.
When I use the same command on a Catalyst 2950 switch, this is what I see when I do a sh run:
interface FastEthernet0/1 switchport mode access
Am I missing something?
Thanks in advance.
read more and respond »Posted 5 years ago by tman in Cisco Systems
