1841 VPN module
Hi guys !
I have a couple of 1841s, two of which I'd like to get explained ;) ...
Take a look at this one ...
Cisco 1841 (revision 7.0) with 116736K/14336K bytes of memory. Processor board ID FCZ1133131E
2 FastEthernet interfaces 1 Serial(sync/async) interface DRAM configuration is 64 bits wide with parity disabled. 191K bytes of NVRAM. 62496K bytes of ATA CompactFlash (Read/Write)... and then at this one:
Cisco 1841 (revision 6.0) with 118784K/12288K bytes of memory. Processor board ID FCZ104220Z3
2 FastEthernet interfaces 2 Low-speed serial(sync/async) interfaces 1 Virtual Private Network (VPN) Module DRAM configuration is 64 bits wide with parity disabled. 191K bytes of NVRAM. 62720K bytes of ATA CompactFlash (Read/Write)I wanted to move the VPN module from the latter one to the first one but after opening the boxes, I found that the AIM slot is empty in both cases. So the following question arises: where do I find the VPN module physically? Or is this just a matter of IOS feature sets?
TIA
fw
read more and respond »Posted 5 years ago by Frank Winkler in Cisco Systems
