2924 + vlans
I have 2 2924's with the WS-X2924-XL-V expansion port in each. I have the trunks between switches set up via port group 1 on 2 interfaces on each swithc. It seems to work well
on switch 2, I have defined a vlan for ports 17-24, however after doing so, i cannot access any network resources.
We have a 2600 upstream, and it doesnt support encapsulation atm, ill have to upgrade it.. however my question is this
I never found a place to define the netowrk range for the second vlan.. Reading up, intervace vlan2 ip add.. is just for management.
So here it is..
Can I configure this second switch (which is trunked up to the main, and hte main goes to the router) to pass all vlans upstream ? Or do I need a subinterface on the router with dotq encap and a vlan defined ?
I am a newb to vlans, the switches work just fine, it is just those 8 ports in vlan 2 that do me no good.
I have this on both trunks
interface FastEthernet1/1 port group 1 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,2,1002-1005 switchport mode trunk ! interface FastEthernet1/2 port group 1 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,2,1002-1005 switchport mode trunk
vlan 1 routes just fine, vlan 2 dies hehe. I understand if you ignore this. But if you have time and dont mind it would rock for some help..
router -> switch1 switch2
the vlan is defined on switch 2.
read more and respond »Posted 5 years ago by turnip in Cisco Systems
