Hi I have a netscreen 5GT, and am trying to set it up for Outlook Web Access (OWA Exchange 2k3). I have set up a custom Policy, but when trying to telnet from the internet, no connection is made to any of the open ports (80, 443...).
I did read about making sure the Management port is different than an "incoming" port, so the management port is now 8080.
Earlier this morning I even decided to reboot the Netscreen to see if the open ports would "kick in". No luck there.
Am I missing a step to open ports properly?
I have searched on the juniper knowledge base and this is what i was told to enter (which I did). set service "Outlook Web Access" protocol tcp src-port 1024-65535 dst-port 25-25 set service "Outlook Web Access" + tcp src-port 1024-65535 dst-port
80-80 set service "Outlook Web Access" + tcp src-port 1024-65535 dst-port
135-135 set service "Outlook Web Access" + tcp src-port 1024-65535 dst-port
443-443 set service "Outlook Web Access" + tcp src-port 1024-65535 dst-port
995-995
Any suggestions?
Al