Can anyone here do remote cisco support for a fee? Availability this morning (Saturday morning 13 Sep 2008 / GMT -0500 / Eastern US time). Need help configuring a 1721 with T1 access.
Please post reply with contact info.
Cheers!
- anthonyx26
This is what I was given for instructions...
- BEGIN INSTRUCTIONS ----------------------------------------
"Since you will use your own CPE, bear in mind the following things to configure:
- "encapsulation frame-relay IETF" on the serial interface
- configure lmi type ANSI
- Create a "point to point" subinterface
- configure DLCI 500 IETF
Sample Cisco Configuration
-------------------------- ! ip subnet-zero ip classless ip routing ! interface FastEthernet 0/0 ip address duplex auto speed auto ! interface FastEthernet 0/1 ip address duplex auto speed auto ! interface Serial 0/0 encapsulation frame-relay IETF frame-relay lmi-type ansi no ip address no shut ! interface Serial 0/0.500 point-to-point ip address [REALIPADDRRESSHERE] 255.255.255.252 frame-relay interface-dlci 500 IETF no shut ! ip route 0.0.0.0 0.0.0.0 Serial 0/0.500 ! "
- END INSTRUCTIONS ----------------------------------------
This is what I was given for instructions...
- BEGIN INSTRUCTIONS ----------------------------------------
"Since you will use your own CPE, bear in mind the following things to configure:
- "encapsulation frame-relay IETF" on the serial interface
- configure lmi type ANSI
- Create a "point to point" subinterface
- configure DLCI 500 IETF
Sample Cisco Configuration
-------------------------- ! ip subnet-zero ip classless ip routing ! interface FastEthernet 0/0 ip address duplex auto speed auto ! interface FastEthernet 0/1 ip address duplex auto speed auto ! interface Serial 0/0 encapsulation frame-relay IETF frame-relay lmi-type ansi no ip address no shut ! interface Serial 0/0.500 point-to-point ip address [REALIPADDRRESSHERE] 255.255.255.252 frame-relay interface-dlci 500 IETF no shut ! ip route 0.0.0.0 0.0.0.0 Serial 0/0.500 ! "
- END INSTRUCTIONS ----------------------------------------
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.