Re: PIX - "No route to" messages - what is causing these ???

In article , Merv wrote: :110001: No route to from

:fw2# sh route : outside 1 OTHER static : outside 1 CONNECT static : outside 1 OTHER static : inside 1 CONNECT static

:inside address is :outside addres is

Did you clean up that 'static' yet as I indicated in response to your previous question? If not, then that's your cause.

If you have access to the CCO then I suggest you go to the tac section and invoke the Output Interpreter tool and push your configuration into it. I suspect it'll tell you of several inconsistancies in your config.

Reply to
Walter Roberson
Loading thread data ... Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.