explain that I did not do so. need to arrange a remote connection, for those who do not know, much has changed in 8.4. this configuration of the docks from the site cisco.com
hostname(config)# interface ethernet0 hostname(config-if)# ip address 10.10.4.200 255.255.0.0 hostname(config-if)# nameif outside hostname(config-if)# no shutdown hostname(config)# crypto ikev1 policy 1 hostname(config-ikev1-policy)# authentication pre-share hostname(config-ikev1-policy)# encryption 3des hostname(config-ikev1-policy)# hash sha hostname(config-ikev1-policy)# group 2 hostname(config-ikev1-policy)# lifetime 43200 hostname(config)# crypto ikev1 outside hostname(config)# ip local pool testpool 192.168.0.10-192.168.0.15 hostname(config)# username testuser password 12345678 hostname(config)# crypto ipsec ikev1 transform set FirstSet esp-3des esp-md5-hmac hostname(config)# tunnel-group testgroup type remote-access hostname(config)# tunnel-group testgroup general-attributes hostname(config-general)# address-pool testpool hostname(config)# tunnel-group testgroup ipsec-attributes hostname(config-ipsec)# ikev1 pre-shared-key 44kkaol59636jnfx hostname(config)# crypto dynamic-map dyn1 1 set ikev1 transform-set FirstSet hostname(config)# crypto dynamic-map dyn1 1 set reverse-route hostname(config)# crypto map mymap 1 ipsec-isakmp dynamic dyn1 hostname(config)# crypto map mymap interface outside nat (inside,outside) source static any any destination static
192.168.0.0 192.168.0.0 route-lookup hostname(config)# write memory n this case a config client connects, is assigned an address from the pool, but local resources can not see, tell me, what is missing.