AP1200 and vlan assignment via radius...

hello,

I have some trouble after assigning another vlan to an user via radius. First I do normal radius authentication and within the Access-Accept reply I send the following back (freeradius):

ahzf Auth-Type := Local, User-Password == "xxx" User-Name = "ahzf-acct", Tunnel-Type = VLAN, Tunnel-Medium-Type = IEEE-802, Tunnel-Private-Group-Id = WLAN-hk

As far as I can see I get connected to the AP and ethernet packets coming from wlan will reach the normal network. But the other way doesn't seem to work at all. No packets coming from the normal network reaches the wlan client...

What's wrong here? Even after looking at debug messages for a while I didn't find a solution...

Firmware version: c1200-k9w7-tar.123-7.JA2

thx... achim

Reply to
Achim 'ahzf' Friedland
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.