WAP54G point-to-multipoint bridge with WPA

I was wondering if anyone else has experienced what I have found. I have three Linksys v2 WAP54G's with 2.07 firmware destined for point-to-multipoint bridge mode operation. (One bridge linked to two other units.) This works fine with no encryption or WEP enabled, but with WPA-shared key encryption it will only work in single point-to-point mode. The hub unit won't link to more than one other unit. There is no mention of this in the docs or knowledge base.


Reply to
Scott & Gayle
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.