7 discussions on Cabling-Design.com Forums about the Cisco SEB4: what owners asked, what went wrong, and what fixed it.
I have three Cisco 2970s... 2970_1 has a trunk to 2970_2 vi Gi0/24 onboth, and a trunk to 2970_3 on Gi0/4 (Gi0/2 on 2970_3)I'm seeing lots of ARP broadcasts for an IP I do not use from a MACaddress that isn't one of mine. I'm trying to...
I have a switch stack consisting of one 3750-24TS-S and one 3750G-24-S. Originally each unit was configured with a name and a management IPaddress, then the two units were connected via the stacking cable(s).No other configuration was done;...
I use a 3550 L2/L3 switch and I need to use a remote dhcp server.I configured it on my router but it didn't work.So I prepared a testing router with a very simple configuration but again I had problem. The request starts regulary, the...
How can I tell if a Cat 3560 is enhanced? I've heard that if it hasan E after the IOS, however looking at the IOS there is an E, but likeso 12.2(25)SEB4. But not sure if that qualifies for E???THanks in advance.
Does anyone know what needs to be added to a privilege level to allowuse of the web administration page for the port config and such, butnot reload and reset to default?
I just brought in a 3560 switch that has 12.2(25)SEB2 installed. Looking at the Cisco site I see that 12.2(25)SEC2 and 12.2(25)SEB4 are also available. It appears as though I am already running the latest release, but I am just curious...