6 discussions on Cabling-Design.com Forums about the Cisco 2950T: what owners asked, what went wrong, and what fixed it.
Hi,I have just completed my CCNA and now looking at getting my CCIP.At the moment I have the following:3 x 2611XM Routers1 x 2522 Router (FR)2 x 2950T SwitchesI noticed that Cisco recommends the following setup for BCSI:6 x 28111 x Router...
Hi,I have little Cisco knowledge.I need a switch to:- configure 2 100Mbits/sec vlans- must be able to monitor traffic on both vlans simultaneously. Thus all traffic of both vlans must be visible on the monitor (dest) port. So the...
Hi,I have two routers (Cisco 877 and Cisco 2610XM), both are connected via Ethernet to a Cisco 2950T switch.The configuration is as follows:Cisco 877 = R0int vlan 1ip address 192.168.0.1 255.255.255.224router ospf 1network 192.168.0.0...
Hi allI want to do some 'sniffing' on my network due to users reportingspeed issues on the LAN, I have PRTG installed but I am not seeinganything unusual in the graphs to indicate high utilisation on the LANI have downloaded and installed...
I have some Cisco Cat2950LRE and 2950T switches in remote locationsthat I can only telnet to sporatically. If I reboot the switch, I cantelnet to it about four times, but on the fifth telnet, the connectiontimes out. This only happens if...
Our network has been rapidly expanding over the past 12 months, andwhat was once a blazing fast network is being bogged down withexcessive broadcasts and misguided network traffic. I'm not an expertCisco admin by any means, so please bare...