Media for ERS 8600, simple setup, IP, VLANs, etc.

ERS 8600, simple setup, IP, VLANs, etc.

Hi I am looking at a relatively simple setup: a dozen networks, each with its own switch and /24 IP subnet are linked to one router which has a link to the campus net. The root router is an

8600 and the leaves are 5530s or 5520s.

The idea is that the 8600 is configured as a pure router, and the 5530s/5520s as pure switches. So the 8600 has N+1 addresses, where N addresses are the gateway addresses used by nodes in the N leaf subnets, and the last one is the address on the link to the campus net. Therefore I also need N+1 routes, N routes to the leaf subnets, and 1 default route to the campus net.

To give some numbers, let's assume:

The link to the campus net has the 192.168.0.0/30 subnet, the 8600 end is 192.168.0.2, the campus net gateway (which is another 8600) is 192.168.0.1.

The leaf subnets are 10.0.1.0/24 to 10.0.12.0/24, and the gateway address each subnet expects is to be the .1 address in each subnet.
The 8600 then must have N ports with addresses 10.0.1-12.1, and one port with the 192.168.0.2 address.

The internet gateway must two routes back to the 8600, one to 192.168.0.2/32 via 192.168.0.1 and the other to 10.0.0.0/8 via 192.168.0.2 (or similar).
One of the leaf networks should be connectable with a MLT connection between the 8600 and its 5530.

So far so good. My questions are:

What address to give to the real or virtual management port? Possibilities: 192.168.0.2, something like 10.0.0.1, something arbitrary, ...

User IP based brouter ports or port based VLANs to bind the 10.0.1-12.1 addresses (and related routes) to the ports to which the leaf switches are connected?
Assuming that this has to be done, how to relay DHCP queries from the 10.0.1-12.0/24 subnets to the campus subnet and responses back to them?

Ideally the choices would satisfy these constraints:

Minimal use of VLANs, in particular avoid on-wire VLAN tags (VLANs entirely internal to the 8600 are sort of OK).

Other then DHCP, no relaying of broadcasts outside the network they originated from. In other words, traffic among the leaf networks (very little is expected anyhow) should be purely routed, and so should traffic between the campus net and the leaf networks, with the exception of DHCP.
The config should be done with CLI commands. In particular the config should be saveable to a text file and checked into a version control system...

Any suggestions and example warmly welcomed, as while I am very familiar with networking configuration in the UNIX/Linux/..., rather less so with the Nortel CLI.