full-duplex mode on NM-1E1R2W
Hello,
i want to use the above network module (one ethernet, one token ring) in a 3640 for a 10mbit leased line with full-duplex.
says : "Supports full-duplex beginning with Cisco IOS Software Release
12.0(4)T"But i can't configure full-duplex on this module, even with 12.1(2)T.
router#show int e4/0 Ethernet4/0 is up, line protocol is down Hardware is AmdP2, address is 0002.1649.d761 (bia 0002.1649.d761) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 128/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) [...]
Does this module supports full-duplex mode? Any hints welcome..
Regards,
Karsten
read more and respond »Posted 5 years ago by Karsten Fischer in Cisco Systems
