Cat-6 Installation Advice
I'm finishing a basement, and leaning towards installing Cat-6 to four data points. My current plan is to run the cable about 6 inches off the ground (to stay below electrical outlets, to attach the cable to the back side of the stud wall by some suitably gentle method, and to run the cable alongside coax and phone cable where they're going to the same place).
1) Despite the fact that I'm not going through the studs, the back side of a stud wall (between the stud and the foundation) is "non-plenum," right?2) Most people sell 1000' spools, but I only need 500'. Is there a search that I should use to find 500' spools of bonded-pair cat6?
3) Am I planning anything dumb?Thanks, Jon
read more and respond »Posted 5 years ago by scary_penguin in General Home Automation
