Media for VPN Client to Soho 97 Roadwarrior

VPN Client to Soho 97 Roadwarrior

Hi,

A colleague is trying to configure a Soho 97 to act as a vpn endpoint for a very small number of mobile workers (around 3). They wont all be connecting at once, and will only connect for small amounts of time, so we can't justify getting new kit in to act as vpn server. We have obtained a license to use the Cisco VPN client which can be downloaded from the cisco site.

The office network topology is very simple.

10.0.2.0/24------[ ethernet0 SOHO97 dialer1 ]-----internet

10.0.2.0/24 is NATted to the outside world. The IP address on dialer1 is negotiated, but always the same.

We would *prefer* - - usernames and passwords specific/unique to each user - no certificates to install on clients - The mobile users to get a dynamically assigned address on 10.0.2.0 (there is a dhcp server on the network that is not the cisco - but we can allocate a range of addresses for use by the mobile workers and take them out of the dhcp pool). We can have a seperate internal network for users dialed in via the vpn if we must though.

We followed the instructions at :

formatting link

The only change was that we put the 'crypto map intmap' bit inside 'int dialer1' and not an ethernet interface. We also added a 'username' line detailing a username and password for someone to use when trying to log in with the vpn client. Everything else was a *direct* copy and paste.

The router didn't seem to be listening out on ports 500 or 10000, so it was no surprise that the cisco vpn client failed to connect to the router....

Soho is running 12.3(2)XC2.

Does anyone have working ios config lines that I can copy and paste?

BR, AS...