Measuring X10 Signal Strength.

I'd like to measure X10 signal strength to diagonse some intermitent problems. I found reference to the "fact" that there's a pin on the decoder chip inside the controlled modules that has either the filtered signal or some amplitude level indication. But no details were given. Before I start tearing apart modules for their tunable inductors to make a filter for the scope...can someone expound on this indication? Thanks, mike

Reply to
Loading thread data ...

Hi Mike,

Try this page;

formatting link
Loads of other invaluable X10 information, too.


Anand Dhuru

mike wrote:

Reply to
Anand Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.