X10 and C-bus

Hi all,

I have a question that I hope someone can answer here in Australia we dont get the same x10 switches that are availale in the US, I like the Clipsal C-Bus switches and these switches appear to be momentary action switches anyways.

I was wondering if it is possible to use these switches with an X10 setup and as I slowly update my light switchs then I can move to c-bus as a phased migration?

Is this possible ?

Thanks Imran

Reply to
Loading thread data ...

You could ask on the charmedquark.com forum (it's a home automation software package). There's a few folks using charmedquark to control their cbus installs, they might know.

formatting link

----------------------------------------------------- Note: I am a mere end-user with no financial stake in any products that I may discuss.

My Personal Website w/my Home Automation PC:

formatting link
last updated 4/11

Reply to

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.