Cisco Wireless -N Home Router WRT120N
Greetings,
Out of the box, I set up the WRT120N router per instructions from the manual.
Problems:
- I need to power-cyle the router every 24 hours for the devices to identify the hotspot, if I don't, the wired router function is fine, but wireless function is dead.
- The "Network Magic" software can't see the DSL modem behing the router (including the command line ping won't respond) so effectively the router has some factory defaults to block certain ports from the LAN to the DSL modem. However the nodes on the LAN are able to see the internet (HTML through traffic is fine, SMTP is fine etc.)
Is this is a known issue with WRT120N? Any firmware upgrades are suggested? How to change the factory defaults on the port configurations? If it is easier to exchange for another model that would be my take instead of upgrades. The manual is a bare-min setup intructions and I am lazy to look them up online. Any responses are appreciated.
TIA The e-mail on the header is a spam filter; please e-mail rigconsulting2@[nospam]yahoo.com for direct responses.
read more and respond »Posted 5 years ago by R I G Consulting, Inc. in Wireless Networking
