1. Home
  2. Virtual Private Networks
  3. VPN to VPN using Linksys BEFVP41 cannot see network subnets

VPN to VPN using Linksys BEFVP41 cannot see network subnets

I set up the vpn router to vpn router like the Linksys says to do. I had to make one site a static IP, so I went and bought that extra service. The remote site is dynamic IP. But when I connect using the remote site router VPN connect I get a connect indication and the log file says success, but when I go to use network places etc I cannot see the other site. I set up the sites to have different subnets, and checked off the netbios enabler. What else should I check? What is a different way to connect?

Reply to
pitc
Loading thread data ...

I believe you need the netbios Broascast (on the BEFVP41s) to be checked on.

formatting link
*&p_li=&p_topview=1

Reply to
Yves Leclerc

Yves Leclerc schrieb:

No.

Netbios broadcasts should *never* cross IP subnet boundaries (M$ says that every IP subnet of a Netbios domain must have its own master browser).

Besides, netbios has nothing to do with IP routing...

Reply to
Martin Bodenstedt

pitc schrieb:

How is your IP routing set up on your remote site?

To access the ip subnets through the vpn in the head office, the pcs in your remote office must "know" to acces them via the vpn head...

Reply to
Martin Bodenstedt

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.