Ok here is what we are trying to do. I have a Cisco 2600 Router and Watchguard SSL VPN and Watchguard 1250e firewall.
I can not seem to get the VPN appliance to work. I have it behind the firewall and a NAT route setup in the firewall for my external address to go to the internal of the VPN and port 443 aqnd 9001 open. Is there something I could be missing in the Cisco?
Can u give us the right diagram to work on.. as if now.. i can only see
Cisco 2600 ----------NAT for SSL --------------> Watchguard 1250e
-------------------------------> SSL
Where are inside hosts ? From where the traffic is coming for VPN? NAT above is correct?
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.