Have a ACS with a continous low battery warning, even with new, tested, batteries. Starange but true, I have two the same way. Even out of the carrier. Reset and power down does not clear, and the memory stays good. Is there a code to put in to clear this alarm ?
TerryS
Have you ruled out a simple contact corrosion problem? Unless the two units are from the same batch (check the serial numbers), it is unlikely that you would get stuck with the same hardware failure on two different units. What release is that, anyways?
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.