Ademco Lynxr - Can't Disarm from Automatic Stay Mode from daily schedule

Have a question or want to start a discussion? Post it! No Registration Necessary.  Now with pictures!

I installed two new window wireless sensors and glass break sensors on zone
 1 (hardwired).  Everything seemed to ok until the first night when I could
n't disarm the panel after the Automatic Stay Mode kicked in over the night
.  The only way to reset was to power down then disarm it with the user cod
e during start-up.  I never had this problem before.  Everything else works
 fine.  I deleted the schedule, powered down, left it alone a few days then
 tried to re-enable the schedule again during the day just to test it out.  
 Same thing happened as before.  Very strange.  Any ideas?  Thanks!

Site Timeline