Ademco Lynx X10 programming Question

I have a number of SH10 powerhorns and light controls set to O. I have the Lynx programmed for #14 which is O in the *25 field. *80 is programmed for SYS PLCD 08 Action=3 Start Action ZT=33 Stop Action ZT=36. When I press code + function + 4 + 8 i get the confirmation beeps but nothing happens. I can press my existing X10 control device to turn on the lights and it works fine. Do I need to program the unit code into the system? If so where? Any suggestions?

Reply to
phurley
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.