Contivity 221 problem

I'm having a hard time getting a Contivity 221 to set up a Branch Office tunnel to a Contivity 1050. The config is ABOT.

Everything appears to be programmed correctly but the tunnel won't establish.

Looking at the logs on the 1050 it is reported that there is a 'Diffie Hellman group mismatch' yet both sides are setup as 3DES/MD5 and DH2 set on the 221. The 1050 is set up with Triple DES with Group 2 (1024 bit prime).

Anybody got any ideas?????

thanx

Ray

Reply to
Ray
Loading thread data ...

Check your remote IP address ranges.

Reply to
Nortec in MN

No - checked that.

The tunnel will come up if I use a fixed WAN address on the Contivity 221. If I use DHCP then the problem arises....

Ray

Reply to
Ray

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.