Configuring Succession 4.5 for IP Phone 2004 using LD 97 & LD 11

Hey all,

I need help configuring my Communication server (Succession v4.5)to allow me to use an IP phone.

The installation guide reads as follows:

Procedure 18 Installing an IP Phone 2004 for the first time

1 Configure a virtual loop on the system using LD 97. For more information, see Software Input/Output: Administration (553-3001-311). 2 Configure the IP Phone 2004 on the system using LD 11. For more information, see Software Input/Output: Administration (553-3001-311).

The referenced manual is only available if you have a Nortel support plan. Is a virtual loop the same as a phontom loop? I'm not very familiar with the Nortel command set, so please include prompts and responses. Thanks so much

Mike

Reply to
mcasey0827
Loading thread data ...

When you buy a system, you should also get or buy the manuals.

LD 97 REQ CHG TYPE SUPL SUPL Vxxx xxx = 0 - 156 and multiple of four for a Large System without FIBN package

365 xxx = 0 - 252 and multiple of four for a Large System with FIBN package 365 In Small Systems, virtual superloops contend for the same range of superloops, 96 - 112, with phantom superloops.

LD 11 REQ NEW TYPE i2002 or i2004 or i2007 or i2050 for the rest almost the same like M39xx sets

Pennyman

schreef in bericht news: snipped-for-privacy@o13g2000cwo.googlegroups.com...

Reply to
Pennyman

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.