Latest threads in Nortel Networksshow only best voted threads

Subject Author Posted Replies
 
BCM 400 V3.7 PRI outbound CLID
You need to build a screening table to screen out anything other than DID numbers. The vendor needs to populate the OLI line to send DID or leave it blank to have your screening table take over and...
3
3
 
gone PRI
Well got my MICS on test PRI. Ran into the problem that the first digit sent to me cannot be the same as a destination code right away. Also no OLI. Am sending the ANI of about the 12th trunk on the...
 
4.0 xc to 4.1 xc upgrade
Greetings been awhile since I did this if I remember correctly I shut down the Norstar pull the 4.0 from the NVROM sleeve put in the 4.1 then power up again and the software should convert leaving all...
 
Compatibility with Cisco VPN
Can I run both at the same time? From same machine?
3
3
 
nortel exams ?
i am looking for nortel exams from . anyone got certmagic guides for these exams ?? . Please share it with me
1
1
 
Screen Pop + CLAN SLink
Hello All, We have Symposium 5.0 which we use for local routing. We use the SLink (Mlink) to connect to Genesys (connects to CLAN IP of Symposium). Is this a dedicated link? If I required a screen pop...
2
2
 
Using a PDA for programming ?
Just wondering if anyone has tried using a PDA for programming. Since my company won't spend $3000 for a nice small laptop, I am looking for any information. (it sucks walking around NYC with a 6 lb...
4
4
 
Nortel 7316E - Name configuration?
Relatively new to the Nortel system and have a quick question. Running a Call Pilot 100 system with Nortel T7316E phones. When I dial another extension from my phone the name that gets displayed is...
7
7
 
alteon health script timeout
Hi, Im using a health check script on the alteon to check a real server: open "80,tcp" send "GET / HTTP/1.1 \\r\\n\\r\\n" expect "HTTP/1.1 200 OK" close Ive read you can increase the time it waits for...
 
CALLPILOT 4 AND OWA PROB
And we are using The Message Forwarding Rule from MY call pilot to forward FAX And voice messages to Exchange 2003 with Trend scanmail Few can view the message body and the attachments from desktop...
1
1
 
cannot ping alteon L4 switch.
Catalyst 6509 connected Alteon L4 Switch 2EA (Active,standby). Catalyst 6509 exists serveral VLANs. so Each VLAN , Even IP Address PC can ping Alteon L4 Switch (Active, Standby) Odd IP Address PC...
1
1
 
CallPilot Networking
Hi, I'm trying to network our CallPilot systems together using VPIM. I have two CPv4.0's talking to each other fine. The problem that comes about is when we try to have the CPv4.0 and BCM400 (v3.7)...
 
Problem with QoS on 5520 using EPM
We have been checking our QoS configurations and have found that the policies created by Enterprise Policy Manager for the 55xx Ethernet Routing Switches are not behaving as expected. Our...
 
Need the big dogs
I have a customer in the Detroit area that I have been cabling for, for 4 years. --About 4 years ago, I cabled 130 workstations with 2, cat6 and 1 cat3. --A year later, I connected a second building...
3
3
 
Alteon : FIN/ACK don't close connection
Hi All Sometimes sessions remain open on my Alteon. Timeout Alteon : 10min Timeout Server : 5min I've done a tcpdump on the client side and on the server : Client send a SYN Server respond with a...
1
1