Hello,
I have a 20 watt halogen lamp that I use to read while in bed.
I power it using a 12-volt power brick. This one is a 60-watt switching powersupply, so it's output is regulated, etc.
It is a nice unit...
I'm using an appliance module to turn it on, and off. But it prefers ON...!
In fact when I use an X10 Maxi-controller to turn it off, I can count to
4 and it turns itself back on again!!Great if you're afraid of the dark... No more than 4 seconds of darkness allowed!
Thanks X10...!
So am I correct to presume that if I mod the module, and remove it's manual turn-on feature, I may get it to work properly??
If so...
Can somebody point me to the how-to site, showing me how to preform said mod?
Thanks, in advance!
Jack :)