Netgear FVG318 Config for travelling user

I have a situation where a Netgear FVG318 seems to be routing *ALL* traffic through the VPN whenever the VPN policy is active, even when there there is no VPN active! When a VPN is active, every device on the LAN can ping the remote user through the VPN and vice versa but not each other. All devices on the LAN cannot even get out to the WAN since all traffic seems to be going through the VPN. The VPN policy was crafted through the VPN Wizard on the FVG318 for a travelling user where the remote IP is not known at configuration time. In this case, according to KB articles on Netgear's site, the remote IP should be set to 0.0.0.0 which ends up being set to "Any" when the VPN policy comes out the other end of the VPN Wizard. It seems to be wanting static routes that state that only traffic intended for the travelling user should go through the VPN tunnel and all else should be routed out through the FVG318 where it either goes out through the WAN port or left inside the LAN but shouldn't the VPN Wizard already have taken care of this? Does anybody have any insight into this? This is with firmware rev 1.33

Reply to
The Tanster
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.