After upgrading to version 8 while using putty, any command I issue that has more than a page does not stop and just scrolls continuously. I their a something I need to change in putty or a command I can issue like a pipe to show per page?
Thanks for your help.
In IOS it's router#term length x
to set it.
term len 0 is no pausing, default is something like
term len 23
I guess it's terminal length.
pix may be similar.
Very similar. Done from config mode, pager lines 24
-Brian
I appreciate the clue. The pix is a little different but close. After reading the man pages, I issued "term pager lines 23" and now it back to the way it was prior to the upgrade. Thanks again!
Pix1# help term
USAGE:
terminal monitor terminal no monitor [no] terminal pager [lines ]
DESCRIPTION:
terminal Set and reset terminal monitor or pagination
SYNTAX:
lines number of lines per page Pix1# term pager lines 23
bod43 wrote:
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.