1. Home
  2. Cisco Systems
  3. PIX - Static mappings to hosts on remote subnets behind PIX

PIX - Static mappings to hosts on remote subnets behind PIX

Hello - I was wondering if it is possible to setup static mappings to hosts on remote IP subnets that are behind the PIX. For example:

Pix outside 1.1.1.1 Pix inside 172.16.144.1

router 172.16.144.2 int e0 router 172.16.145.1 int e1

host 172.16.145.2

The host has its default gateway at 172.16.145.1 and has full IP connectivity both ways to the PIX and can get out to the internet. Can I do a static NAT or PAT to the host 172.16.145.2? If so how is this accomplished? I have tried this without success, I am able to create static mappings to hosts that are on the same IP subnet as the inside interface but not to hosts that are on remote IP subnets.

Thanks, Ben

Reply to
btercha
Loading thread data ...

sure can, done the same as any other static... for nat static (inside,outside) netmask 255.255.255.255 for pat static (inside,outside) interface netmask 255.255.255.255

make sure the pix has a route for that other subnet (route inside

172.16.45.0 255.255.255.0 172.16.144.2
Reply to
Brian V

Reply to
btercha

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.