=C4=B0 have just set up point ot point Metro ethernet on switchs,i want to back up this link with using L3 cisco switch.primary link is metro ethernet,secondary is wireless bridge.Which protocol i can use for load balancing and terminating this ethernets.
Best regards.
I believe EIGRP is the best for this purpose as you can assign certain metric to each link and share traffic among them accordingly. Some thing like this:
router eigrp 1 network x.x.x.x variance 2 traffic-share balanced
Actually i have no router, i would like to use L2 or L3 catalyst=20 switch on the backbone with HSRP redundancy , if i can deploy OSPF in=20 this case networks works fine ,becaouse we're planning OSPF on the=20 backbone area.
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.