config. RSTP
Bookmark this page:
 Yahoo!
 Google
 Windows Live
 del.icio.us
 digg
 Netscape
|
|
||||||||||||||||
|
Posted by on May 9, 2008, 1:31 pm
Please log in for more thread options 1. Does people need manually config a Alternate port? 2. Same qutsion above about backup port. 3. Why someone say RSTP convergence time within 1s? from power up stage to stable stage? or from topology change to stable stage? or just for some special case? TIA, st | ||||||||||||||||
|
Posted by headsetadapter.com on May 9, 2008, 6:01 pm
Please log in for more thread options change (primary path goes down) to a stable state (previously blocked redundant link goes into Forwarding mode). To speed up the time from the port become active to the time it starts forwarding traffic, use "spanning portfast" (or "spantree portfast" on IOS). There is no way to forward any port until the router actually load and run all software (time from power up). Good luck, Mike CCNP, CCDP, CCSP, CCVP, MCSE W2K, MCSE+I, Security+, etc. CCIE R&S (in progress), CCIE Voice (in progress) ------ Headset Adapters for Cisco IP Phones www.ciscoheadsetadapter.com www.headsetadapter.com | ||||||||||||||||
| Similar Threads | Posted |
| config. RSTP | May 9, 2008, 1:31 pm |
| RSTP info on proposal | March 6, 2007, 8:34 am |
| stp,rstp and mstp comparison | August 6, 2007, 11:26 am |
| RSTP Diameter question. | August 9, 2008, 1:25 am |
| Why Bridge configuration filters RSTP (BPDU packets) from LAN | April 2, 2006, 6:08 am |
| initial config of 3560, set config, cant ping~~nv_done: unable to open "flash:/C:\new\config.new | February 5, 2008, 11:39 pm |
| copy startup-config running-config ??? Why is this command not used. | April 1, 2007, 12:01 am |
| 2924 Switch: VLAN config not in config.text | May 22, 2007, 5:23 am |
| can not save running-config to startup-config. | November 10, 2005, 11:56 am |
| IOS IDS config ? | July 13, 2005, 4:03 pm |
| QoS Config | July 14, 2005, 9:30 pm |
| Config of a 515 PIX | July 31, 2005, 9:12 am |
| Help config Pix 501 . . . please | September 11, 2005, 1:18 pm |
| need config help | October 24, 2005, 3:15 pm |
| Please help with 515 config | November 7, 2005, 2:28 pm |
>
> 1. Does people need manually config a Alternate port?
> 2. Same qutsion above about backup port.
> 3. Why someone say RSTP convergence time within 1s?
> from power up stage to stable stage?
> or from topology change to stable stage?
> or just for some special case?
>
> TIA,
> st