|
Posted by Hoffa on December 5, 2006, 12:58 am
Please log in for more thread options
Hello all
I have this wierd problem with a FWSM I just converted to multicontext
mode. I have only one context configured so far. It's an exact replica
of the configuration the FWSM had when it was in single mode, this
context is also the admin context.
When the firewall was in single mode it rarely dropped any packets, we
use Solarwinds to monitor that, but the same config as an admin context
droppes alot of recieved packets. Nearly as many packets as valid ones.
How can this be? Is it that one cannot run the admin context as a
production context?
Regards
Fredrik Hofgren
|
| Similar Threads | Posted |
| Large amount of dropped packets on FWSM in multicontext | December 5, 2006, 12:58 am |
| Dropped packets via ISR | August 23, 2006, 9:46 am |
| dropped packets | February 15, 2007, 5:11 am |
| I need Help tracking down where packets are being dropped.. | March 6, 2007, 10:22 am |
| 6513 with HSRP and F5 causing Dropped packets | March 5, 2008, 6:36 pm |
| Pix & large ping packets | May 3, 2007, 9:58 am |
| Amount of flash simms in 3640 | September 12, 2006, 7:06 am |
| Measure amount of network usage | May 27, 2008, 3:33 am |
| show amount of traffic passing throw interface | October 18, 2007, 10:41 am |
| VoIP + 3650 PoE = Echo + Dropped Calls...etc | November 29, 2006, 4:56 pm |
| ASA 5520 dropped some packet from inside interface, Please help | April 25, 2007, 2:55 pm |
| IOS Request For Validation: Noninitial fragments dropped due to reflexive ACL evaluation on outbound subinterface. | June 30, 2007, 5:58 pm |
| Large-Scale Dial-Out | October 16, 2005, 10:29 am |
| Audit of large Cisco Network | February 8, 2005, 1:41 pm |
| Large IP Block = Lots of ARP traffic | July 17, 2005, 11:10 pm |