Wic 1Eth

Have a question or want to start a discussion? Post it! No Registration Necessary.  Now with pictures!

Threaded View
Hi

I am getting the following error when installing  wic 1Eth on a 2612
router, its using IOS (tm) C2600 Software (C2600-BIN-M), Version
12.2(11)T,  RELEASE SOFTWARE (fc1) which I believe should support this,
although I have read many conflicting reports

         WIC Slot 1:
         Unknown WAN daughter card
         Hardware Revision        : 3.0
         Part Number              : 73-5797-03
         Board Revision           : A0
         Deviation Number         : 0-0
         Fab Version              : 02
         PCB Serial Number        : f0c09347052
         RMA Test History         : 0D
         RMA Number               : 0-0-0-0
         RMA History              : 00
         Top Assy. Part Number    : 800-09311-03
         Connector Type           : 01
         Chassis MAC Address      : 0004.dc0c.b583
         MAC Address block size   : 29559
         EEPROM format version 4
         EEPROM contents (hex):
           0x00: 04 FF 40 00 39 41 03 00 82 49 16 A5 03 42 41 30
           0x10: 80 00 00 00 00 02 02 C1 8B 66 30 63 30 39 33 34
           0x20: 37 30 35 32 03 0D 81 00 00 00 00 04 00 C0 46 03
           0x30: 20 00 24 5F 03 05 01 C3 06 00 04 DC 0C B5 83 43
           0x40: 73 77 FF FF FF FF FF FF FF FF FF FF FF FF FF FF
           0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
           0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
           0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

Re: Wic 1Eth
On Wed, 13 Jun 2007 10:37:40 +0100, Kevin Wincott

Quoted text here. Click to load it

That module is only supported on the 17xx series of routers. To get
more ethernet ports, you'll have to use a NM (Network Module), not a
WIC.


Tom

Site Timeline