Pix configuration - default Gateway?

I'm more familiar with Sonicwall than Pix but an expert at neither.

I have a pix box that I can access via the web interface. I'm trying to figure out where I would find the default gateway on it. When I click on the interfaces, I can see my inside and my outside IP address but I don't see the DNS or Gateway information that I would normally put in the Sonicwall.

Thanks

Reply to
boe
Loading thread data ...

Thanks!

Reply to
boe

Yo

You can use in CLI : route INT 0.0.0.0 0.0.0.0 X.X.X.X with X.X.X.X : the IP address of the gateway and INT : the "nameif" of the interface where you want to set the default route ....

or if you use the PDM : IN the MODE "configuration" , TAB "System Properties" , CLICK on "Routing" : You can set a static route ....

Wood

boe a écrit :

Reply to
GIRAUDO Robin

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.