Have a question or want to start a discussion? Post it! No Registration Necessary.
Now with pictures!
- RatRace2
August 3, 2006, 2:51 am

Hello:
After my 2950 switch boots up all I get is this:
This show up as the last message in
the boot sequence_____________
% authentication failed
Then the switch displays:_________________
atl-sw con0 is now available
press return to get started.
_____________________________
o.k: I press enter, but no "switch >" command prompt..
I just keep getting the same thing.................................
__________________________________________
atl-sw con0 is now available
press enter to get started
__________________________________________
this is what is says over and over but no command prompt.
HUGGGGGGGGGGGGGGGGGGGGGGG........
After my 2950 switch boots up all I get is this:
This show up as the last message in
the boot sequence_____________
% authentication failed
Then the switch displays:_________________
atl-sw con0 is now available
press return to get started.
_____________________________
o.k: I press enter, but no "switch >" command prompt..
I just keep getting the same thing.................................
__________________________________________
atl-sw con0 is now available
press enter to get started
__________________________________________
this is what is says over and over but no command prompt.
HUGGGGGGGGGGGGGGGGGGGGGGG........
Site Timeline
- » Making The Pirate Bay obsolete
- — Next thread in » Cisco Certification
-
- » ip routing command and InterVLAN routing
- — Previous thread in » Cisco Certification
-
- » iPhone SUPER 80% discounts
- — Newest thread in » Cisco Certification
-
- » Helper Woes
- — The site's Newest Thread. Posted in » CCTV, Alarms and other Physical Security
-