Some question on Orcad PCB editor (from an Orcad layout user)
Bookmark this page:
 Yahoo!
 Google
 Windows Live
 del.icio.us
 digg
 Netscape
|
|
|||||||||||||
|
Posted by maccumba on November 4, 2007, 6:11 pm
Please log in for more thread options for first, if someone have used Orcad Layout too there is a significant improvement in upgrading to PCB editor ? On PCB Editor: - In Layout The spacing violation control (Design Rule Check)signal like errors the simple hole too and i don't know how exclude the holes from DRC , in PCB Editor the situation is better then layout ? - Spacing from Nets : can i set (for a single net) a minimum spacing from a group of nets and another spacing from a different grouping nets ? - Mills or notches : in Layout i need to make some notches on the PCB for isolation , in layout the only way is a lot of consecutive holes (for now i don't know a better way...and this create the problem with DRC ) , what is the way to describe a mill/notch in PCB Editor ?? And for last, Allegro PCB Designer is the same or there is difference ? Thanks in advance. Andrea | |||||||||||||
|
Posted by Marra on November 4, 2007, 6:20 pm
Please log in for more thread options If the hole is too close to something then it needs fixing. www.ckp-railways.talktalk.net/pcbcad28.htm | |||||||||||||
| Similar Threads | Posted |
| Some question on Orcad PCB editor (from an Orcad layout user) | November 4, 2007, 6:11 pm |
| Orcad Layout 7 question: changing silkscreen widths? | March 9, 2005, 1:21 pm |
| Orcad newbe question | January 30, 2005, 3:41 pm |
| OrCAD newbie question | August 28, 2006, 7:42 pm |
| Elementary OrCAD question | March 6, 2008, 2:04 am |
| Orcad Layout | August 16, 2004, 7:57 am |
| OrCad layout export | October 7, 2004, 11:04 am |
| Orcad Layout(new file) | August 7, 2006, 5:01 pm |
| Doing Layout on two outer layers in OrCAD | January 19, 2006, 8:59 pm |
| OrCAD Layout - good ground | January 31, 2006, 9:35 am |
| Orcad Schematic to Layout Link | March 21, 2006, 1:01 am |
| orcad layout datum moving | August 5, 2006, 6:29 pm |
| Orcad Layout 10.3 Free Via Issue | May 23, 2007, 10:43 am |
| Orcad Layout finally dead | June 21, 2007, 8:54 am |
| orcad layout 10 does not print top layer | July 21, 2007, 12:12 pm |